columbuscros.blogg.se - Aquaterm 63m socket fusion die

Added to this are the exceptionally good welding properties and the fusion into a homogeneous and. Insert pipe into fitting at a smooth and steady rate all the way to the stop or markpreviously made by the depth gauge aquatherm blue pipe made of corrosion-resistant polypropylene is a specialist for the transport of cooling.Do not make any axial movements in the pipe while the joint is cooling.

Ensuring the heating iron is at the proper temperature before attempting to fuse.

Making the pipe ends square before fusing.

item 2 McElroy Plastic Socket Fusion Iron Heater 800W with 2-8 IPS Serrated Adapter Set McElroy Plastic Socket Fusion Iron Heater 800W with 2-8 IPS Serrated Adapter Set. The gap can be eliminated or brought to within allowances by: Find many great new & used options and get the best deals for McElroy Socket Fusion Plastic Welder Aquatherm Kit 442901 & Sockets at the best online prices at eBay. harsh and dangerous chemicals) Level I should be used.Īllowable Gap Between Pipe End and Fitting Aquatherm generally uses the acceptance level II for water systems (plumbing, hydronic, etc. The following table indicates the allowable gap, x, between the pipe end and the stop in the socket. SD = Socket Depth (Gap, x, greatly exaggerated for clarity) Auch die vorisolierten aquatherm blue pipe ti Rohre werden mit dem Muffenschweiverfahren zu einer stoffschlssigen Einheit verbunden.

Any of these conditions, or other incorrect operating conditions/procedures, must be corrected and the joint cut out and replaced.įigure 1: Typical Socket Connection. There are other conditions which may also result in a gap, or the pipe not being fully inserted, such as incorrect heating time or temperature, fusion heads not fully engaged on pipe and fitting when heating, axial movement during the cooling phase, stopping and starting while making the joint, or surface contamination. In these cases, a slight gap is acceptable, provided it is within the parameters given in the Table below. However, there may be times when the pipe is not be fully inserted, the pipe end is not cut square, or the pipe is inserted at a slight angle, resulting in a small gap. This gap will not normally be present if the Aquatherm fusion procedures are followed. In some cases a small gap may occur between the end of the pipe and the vertical pipe stop at the bottom of the socket when socket fusing Aquatherm pipe.